Setup guide
1 Fold the face-up tray
upward, then fit the tray’s
right coupling arm into the
corresponding hole in the
printer.
When doing this, hold the
metal spring leaf (ends in a
loop) close to the face-up tray.
»Note:
Make sure that the metal spring leaf extends downward
from the tray and does not enter the hole in the printer.
2 Fit the face-up tray’s left
coupling arm into the hole
in the printer.
3 Holding the multipurpose
tray with both hands, fit the
coupling arm on the right
into the slot on the printer
.
4 Fit the multipurpose tray’s
left coupling arm into the
slot on the printer, and
press downward on the left
coupling arm until it latches.