Specifications

www.crownaudio.com
62 •
AMPLIFIERS  CINEMA
Other Cinema Products
CTs
Multi-Channel
POWER OUTPUT*
All channels driven All channel pairs driven
Models 4-ohm Dual 8-ohm Dual 70V Dual 8-ohm Bridge
CTs 4200 260W 200W 220W
**
520W
CTs 8200 200W 160W 200W
**
400W
*Maximum average power in watts at 1kHz at 0.1% THD.
**Constant Voltage full-bandwidth power ratings support 100 Hz to 20 kHz due to automatic
high-pass fi lters.
XLS Series
POWER OUTPUT*
4-ohm Dual 8-ohm Dual 8-ohm
Model
(per channel) (per channel) Bridge
XLS 202 300W 200W 600W
XLS 402 450W 300W 900W
XLS 602 600W 380W 1,200W
XLS 802 800W 500W 1,600W
*Maximum average power in watts at 0.5% THD, 1 kHz.
POWER OUTPUT*
2-ohm Dual 4-ohm Dual 70V Dual 4-ohm
Models (per channel) (per channel) (per channel) Bridge
CTs 600 150W** 300W 300W 300W**
CTs 1200 250W** 600W 600W 500W**
CTs 2000 1,000W 1,000W 1,000W 2,000W
CTs 3000 1,500W 1,500W 1,500W 3,000W
*Maximum average power in watts at rated THD, 20 Hz - 20 kHz.
** At 1 kHz.
CTs 2-Channel
Regulatory Certifications
CTs 600, CTs 1200, CTs 2000, CTs 3000, CTs 4200, CTs 8200
CTs Series
CTs, DSi and XLS Series CTs Series
CTs Series
DSi, XLS Series
FEATURES
High power density: Four-channel model in a 2U
chassis, eight-channel model in a 3U chassis.
New Crown Switching Power Supply for lighter
weight.
Selectable “Constant-Voltage” or low-imped-
ance (4/8 ohm) operation per channel-pair.

•
•
•
FEATURES
Housed in a rugged, all-steel 2U chassis.
Effi cient forced-air fan prevents excessive ther-
mal buildup.
Electronically balanced XLR inputs; touchproof
binding post and Speakon outputs.
Precision detented level controls, power switch,
and four LEDs, which indicate clip for each
channel, power and fault conditions.

•
•
•
•
FEATURES
High power density. All two channel models in
a 2U chassis.
New Crown Switching Power Supply for lighter
weight.

•
•
Selectable “Constant-Voltage” or low-imped-
ance operation per channel.
100V direct outputs on CTs 2000, CTs 3000.
Fully PIP2™-compatible.
•
•
•
100V direct outputs.
New “FIT” (Fault Isolation Topology) circuitry
isolates fault conditions without affecting neigh-
boring channels.
Accept VCA-MC accessory modules.
•
•
•
Note: For more information about the products featured in this section, please refer to the following pages:
CTs 2-Channel: page 4, CTs Multi-channel: page 6, XLS Series, page 36.