Specifications

International Radio and Electronics Corporation

25166 Leer Drive Elkhart, Indiana 46514 • 574–262–8900 • www.irec1.com

5.4 TROUBLESHOOTING GUIDE FOR CROWN/OMNIA DP3

In the unlikely event that you should encounter problems with your Crown/Omnia DP3,

below is a short guide that might aid in more common problems that could occur.

Problem Possible Solutions

1) Cannot connect to DP3 via

ETHERNET port.

a) Computer is not configured correctly to talk to the DP3.

Consult ‘Network Configuration Guide’ for instructions

for setting up the computer ETHERNET card (static IP

address).

b) The wrong address was entered into the address bar.

Re-enter the following : http://192.168.0.243

c) Wrong type of cable connected to Crown/Omnia DP3.

For direct connection, use a ‘cross-over’ cable. Obtain one

from a local computer retail store. For a connection to a

network, use a ‘straight-thru’ type.

d) The IP address of the network that the DP3 is

connected to is something other than what the DP3 is set

for. You must connect to the DP3 direct to change the

settings on the DP3 to match the network settings. This

must be done with a ‘cross-over’ cable. Consult ‘Network

Configuration Guide’ and ‘ETHERNET Port Guide’ for

more information.

2) After changing the

ETHERNET port settings on

the DP3, can no longer

connect to the DP3.

You must change the network card settings of the

computer you are using to connect to the DP3, to match

the setting you are using for the DP3 card. Consult

‘Network Configuration Guide’ and ‘ETHERNET Port

Guide’ for more information