Specifications

International Radio and Electronics Corporation

25166 Leer Drive Elkhart, Indiana 46514 • 574–262–8900 • www.irec1.com

3.10.3 Transmit

1. Turn on the Carrier switch

2. Check the following parameters from the Readings, Primary function list:

RF Power : RF Power varies by model:

29–33 watts for the FMX30

95–110 watts for the FMX100

250-275 watts for the FMX250

SWR : Standing wave ratio should be less than 1.1. A reading greater than 1.25 indicates

an antenna mismatch.

ALC : Automatic level control should be between 4.00 and 6.00 volts.

PA DC V : PA DC Volts varies by model, antenna match, power, and frequency.

Typical readings are:

26–30 volts for the FMX30

25–35 volts for the FMX100

37-52 volts for the FMX250

PA DC I : PA DC Amperes varies with model, antenna match, power, and frequency.

Typical readings are:

1.5–2.5 amps for the FMX30

3.04.5–6.5 amps for the FMX100

6.0–8.0 amps for the FMX250

PA Temp : PA Temperature should initially read 20–35 degrees C (room temperature).

After one hour the reading should be 35–50 degrees C. Maximum operating temperature

is 55 degrees C.

PS DC V : Supply DC volts varies by model. It should read 45 volts with the carrier on

and 50 volts with the carrier off for both the FMX30 and FMX100 products. For the

FMX250, the readings should be 65 volts with the carrier on and 75 volts with carrier off.

Voltmeter : This reading should be 0.0.