Specifications

International Radio and Electronics Corporation
25166 Leer Drive Elkhart, Indiana 46514 • 574–262–8900 • www.irec1.com
3
-
6
[DPC Version] Software version of the digital power control.
[MDC Version] Software version of the metering digital control.
[ RMS Version] Version of software installed in the optional Remote Management
System.
[Back] Returns to the previous menu.
3.6 Settings Function List
Settings functions change operating parameters and alarm limits. A password is
required for access to Settings functions. The Settings list is also divided into two
submenus:
Primary, is for more frequently used settings, and Secondary for less frequently used
settings.
[Primary]
[TX] Turns carrier on or off.
[RF Power Set] Sets the RF output power level.
[Tx Freq] Sets the transmitter carrier frequency from 4 presets that are editable in a sub
menu directly in this menu.
[Stereo] Selects the transmission mode.
[Audio Gain] Sets the audio input sensitivity. Choices for audio gain are:
0 dB
+6 dB
+12 dB
+18 dB
[RF Power Warn] Sets level of low RF power level fault.
[Pre-Emphasis] Set the pre-emphasis level for the audio processor. Choices are 0 uS, 25
uS, 50 uS, or the default level of 75 uS.
[Audio Proc Ctrl] This is the processing control setting. Use it to determine the amount
of processing desirable. For little or no processing, set close to zero. For heavy
processing, set close to 100. Default value is 50.