Specifications

International Radio and Electronics Corporation

25166 Leer Drive Elkhart, Indiana 46514 • 574–262–8900 • www.irec1.com

• Torque the PWA hardware @ 14 inch-Lbs.

• Check and set the Audio Input Impedance High/Low jumper settings on the

Crown/Omnia PWA to the value needed.

• These jumpers are shown in FIG 23 & 24.

FIG 23 FIG 24

• Install ribbon cable as oriented in FIG 25.

• Install the ribbon cable at J11 as shown in FIG 26.

FIG 25 FIG 26

• Plug other end of ribbon into P5 of the Metering PWA as shown in FIG 27.