Specifications

International Radio and Electronics Corporation

25166 Leer Drive Elkhart, Indiana 46514 • 574–262–8900 • www.irec1.com

• Remove the DD Hole Plug from the Back Panel “Receiver In” hole.

• Remove the White retaining clip as indicated in FIG 7 and set aside for later use.

• Feed the Omnia Ethernet cable through the “Receiver In” hole as shown in FIG 8.

FIG 7 FIG 8

• Feed the Omnia Ethernet cable completely through and put into DD hole opening as

shown in FIG 10.

NOTE: Locking tab on cable bulkhead should point upwards as shown in FIG 9.

FIG 9 FIG 10

• Slide the white-retaining clip onto cable and lock into place as shown in FIG 11 & 12.

FIG 11 FIG 12