Specifications

International Radio and Electronics Corporation

25166 Leer Drive Elkhart, Indiana 46514 • 574–262–8900 • www.irec1.com

FIG 16 FIG 17

• Using the 6-32 hardware from the old PWA removal, fasten the new PWA to the

Motherboard as shown in FIG 18.

FIG 18

• Torque the PWA hardware @ 14 inch-Lbs.

• Check and set the Audio Input Impedance High/Low jumper settings on the

Crown/Omnia PWA to the value needed.

• These jumpers can found as shown in FIG 19 & 20.