Specifications

International Radio and Electronics Corporation
25166 Leer Drive Elkhart, Indiana 46514 • 574–262–8900 • www.irec1.com
1
-
3
FIG 2
• Remove the DD Hole Plug from the Back Panel “Receiver In” hole.
• Remove the White retaining clip as indicated in FIG 3 and set aside for later use.
• Feed the Omnia Ethernet cable through the “Receiver In” hole as shown in FIG 4.
FIG 3 FIG 4
• Feed the Omnia Ethernet cable completely through and put into DD hole opening as
shown in FIG 6.
NOTE: Locking tab on cable bulkhead should point upwards as shown in FIG 5.