Mega-Stor Indirect Fired Water Heater Installation Manual

15
WARNING
A thermostatic mixing valve does not eliminate the risk of scalding.
* Set the Mega-Stor thermostat as low as practical.
* Feel water before bathing or showering
designed for such service. Install these devices in accordance with their
manufacturer’s instructions.
DOMESTIC WATER PIPING FOR DISTANT FIXTURES
the Mega-Stor. A small bronze circulator is mounted in this line and is wired so as to run continuously. A check valve in this line
MEGA-STOR PIPING WITH A “TEMPERATURE LIMITING VALVE”
Usually, the maximum temperature of the outlet water will stay near the setting of the Mega-Stor control. In some cases, however,
This device blends a controlled amount of cold water with the hot water leaving the Mega-Stor so that water at a more constant
temperature exits the mixing valve. Typical thermostatic mixing valve piping is illustrated in Figure 7.8. Consult a licensed
plumber or the local plumbing authority for requirements in your area.
FIGURE 7.5: AQUASTAT INSTALLATION