IQ-PIP-USP2 ADAPTER INSTALLATION MANUAL © 2002 by Crown Audio Inc., P.O. Box 1000, Elkhart, Indiana 46515-1000 U.S.A. Telephone: 574-294-8000. Trademark Notice: PIP and PIP2 are trademarks and Com-Tech, Crown, IQ System and Macro-Tech are registered trademarks of Crown International. Other trademarks are the property of their respective owners. 133394-2 10/02 Rev.
IQ-PIP-USP2 Adapter Installation Manual 133394-2 Rev. B The information furnished in this manual does not include all of the details of design, production, or variations of the equipment. Nor does it cover every possible situation which may arise during installation, operation or maintenance. If you need special assistance beyond the scope of this manual, please contact the Crown Technical Support Group. Mail: P.O. Box 1000 Elkhart IN 46515-1000 Shipping: 1718 W.
IQ-PIP-USP2 Adapter Installation Manual 133394-2 Rev. B Revision History Revision Number Date Rev. A Rev. B 8-2001 10-2002 © 2002 Crown Audio, Inc. Comments Initial Printing Revised date, rev level, Crown logo, area code, Section 1.2, Section 3.2, and Figure 3.3.
IQ-PIP-USP2 Adapter Installation Manual 133394-2 Rev. B Table of Contents 1 Introduction.............................................................................. 5 1.1 Introduction .............................................................................................. 5 1.2 The IQ-PIP-USP2 Adapter ....................................................................... 5 1.3 Warranty...................................................................................................
IQ-PIP-USP2 Adapter Installation Manual 133394-2 Rev. B 1 Introduction 1.1 Introduction This manual contains information necessary for setup and installation of the IQ-PIP USP2 Adapter into non-PIP2 TM-compatible Crown® power amplifiers. It is designed to be used in conjunction with the IQ-PIP USP2 Reference Manual. NOTE: THE INFORMATION IN THIS MANUAL IS INTENDED FOR USE BY AN EXPERIENCED TECHNICIAN ONLY! NOTE: REMOVING THE COVERS OF THE AMPLIFIER VOIDS ALL AGENCY APPROVAL RATINGS. 1.
IQ-PIP-USP2 Adapter Installation Manual 133394-2 Rev. B 2 Controls and Connectors Figure 2.1 IQ-PIP-USP2 Adapter Controls and Connectors 6 © 2002 Crown Audio, Inc.
IQ-PIP-USP2 Adapter Installation Manual 133394-2 Rev. B 3.3 Prepare the Amplifier 3 Installation 3.1 General Information Before beginning, please carefully note: CAUTION: STATIC ELECTRICITY MAY DAMAGE THE IQ-PIP USP2 ADAPTER and/or the IQ-PIP USP2 MODULE. Use caution when handling these units. Carefully ground yourself BEFORE touching the modules. Don’t unnecessarily touch the connectors, components or solder pads on the circuit boards. 3.2 Prepare the Adapter 1. Set the Amp Scaling Factor DIP Switches.
IQ-PIP-USP2 Adapter Installation Manual 133394-2 Rev. B 3.5 Install the IQ-PIP USP2 Module 1. Locate the two connectors on the underside of the PIP circuit board (figure 3.5), then connect the two input ribbon cables coming from the IQ-PIPUSP2 Adapter. Both ribbon cables should run smoothly from the amplifier to the PIP module. Figure 3.3 PIP Edge Connector Dissassembly 3.4 Install the IQ-PIP USP2 Adapter Refer to Figure 3.4 for locations of the parts described in this procedure. 1.
IQ-PIP-USP2 Adapter Installation Manual 133394-2 Rev. B 4.2 Feature Differences 4 Operation 4.1 General Information This section provides information about using the IQ-PIP-USP2 in an amplifier with the IQ-PIP-USP2 Adapter installed. Important: The IQ-PIP-USP2 Adapter requires IQ for Windows, version 5.02 or newer. Older versions of the software will not recognize the adapter and allow communication with the IQ-PIP-USP2.
IQ-PIP-USP2 Adapter Installation Manual 133394-2 Rev. B 4.2.3 Peak Voltage and Average Power Voltage Limiters Peak Voltage and Average Power Voltage Limiters are not available. Refer to Figures 4.4 through 4.6. Figure 4.5 “Peak Voltage Limiter” Block Disabled on “Signal Path” Tab Figure 4.4 “Signal Path” Tab Showing Peak Voltage and Average Power Limiters Disabled Figure 4.6 “Average Power Limiter” Block Disabled on “Signal Path” Tab 10 © 2002 Crown Audio, Inc.
IQ-PIP-USP2 Adapter Installation Manual 133394-2 Rev. B This page intentionally left blank © 2002 Crown Audio, Inc.
