User's Manual
DriveCore Install Network Series Power Amplifiers
Operation Manual
page 26
Bridge Mode Hi-Z (140Vrms/200Vrms)
INPUTS: Connect the input to the odd-numbered channels
(1,3,5,7) only. Even-numbered inputs are disabled when the
Bridge Mono mode is active.
OUTPUTS: Connect the speaker across the positive terminals
of each channel pair. Do not use the negative terminals of the
channel pair when the pair is being operated in Bridge Mono
mode.
NOTE: For global selection of 70Vrms (140Vrms
bridged) or 100Vrms (200Vrms bridged) operation,
refer to Page 25.
Figure 25 System Wiring for 140Vrms/200Vrms Operation
Figure 26
Set-up and System Conguration
Always route the input and output wires in separate bundles.