Specifications

CS-47 GSM Link - Configuration Guide Chapter 4 - Installing the Hardware Unit
8
CHAPTER 4.
Installing the Hardware Unit
IMPORTANT NOTES
If the GSM unit is being installed as a backup module, it should
NOT be installed too close to the panel.
It is recommended to configure the unit at the lab before
installing it at the customer’s premises.
 To install the hardware unit containing the CS-47 GSM link:
1. Chooseasuitablelocationwithinthesecuredareafortheunitwithin1to20
metersfromtheRunner.
2. Usingthepapertemplatedrill4holesinthewalltomounttheunit.
3. Usingfourscrewsandrawl‐plugs(wallplugs),fixtheunittothe
wallorany
otherfirmflatsurface.
4. PowerOFFtheRunneranddisconnectthebackupbattery.
5. ConnecttheunittotheRunnerbus.

Thebusconsistsoffourwires:Pos(+12V),Neg(‐12V),ClkandData.
SeePage6
6. IftheCS‐47linkis
goingtouseanexternal12VpowersupplytheGNDwire
fromthepowersupplyMUSTbeconnectedtotheGNDBus(Neg)terminal.
7. InserttheSIMcard intotheSIMcardholder.

Ifyouhaven’tcancelledcallwaitingandallroamingoptionsitisrecommended
todoso
bycontactingyourISP(InternetServiceProvider).
8. Ensurethattheantennaisproperlyconnected.
9. PowerONtheRunner.
10. Connectthebackupbattery.