Instructions / Assembly

4
6.4.
5.
Positionthelowerextrusionaligning
itwiththeproposedrailingdirection
(Fig.6).Ensurethatthepre-
mountedtopcenteringextrusionis
aligned as well.
Note:
RDIrailingkitsaremanufactured
fora36"or42”finished-railheight
witha2"standardbottomspace.
Ifotherheightsorbottomspaces
aredesired,adjusttheheightofthe
centeringextrusionaccordingly.
Note:
IfinstallingEndurance
®
ADA Hand
Rail™ontoapost,determinethe
mountinglocationandcreate
sufficientattachmentbyblocking
outpostwith1”materialorby
purchasingathirdcentering
extrusionandinstallingatdesired
location(Fig7).
Slidethevinylsleeveoverthe
centeringextrusion.Markandcut
the sleeve to length.
Tip:
Thesleeveshouldextendabovethe
desiredrailheightenoughtoallow
clearanceforapostcap(Fig.8).
Note:
Ifusingaturnednewelsleeve*,be
suretoleaveenoughflatareato
acceptrailattachmentbrackets
(Fig.9).Removethetopcentering
extrusionsetscrewandthe
extrusion.Usethisscrewtoattach
thebottomcenteringextrusionto
thepost.Slidethetopextrusion
ontothepostaftertheturnedsleeve
has been installed.
*Endurancerailkitsmeasure34”or
40”fromthebottomofthebottom
railtothetopofthetoprail.
Slidethevinylsleeveoverthestruc-
turalpostandthecenteringextru-
sions(Fig.10).
Note:
Thetopcenteringextrusionmay
needtoberepositioneddepending
onyourapplication.Forexample,in
stairrailingapplications,thecenter-
ingextrusionmayneedtoberaised
toallowattachmentofthestair
brackets.
(Fig. 7)
(Fig. 10)(Fig. 8)
(Fig. 9)
6.5"Minimum
(Fig. 6)
34"or40"*