Owners Manual

112146-61 www.amdry.com 35
PL16
AGt
Perm Press
10 HI Temp
Perm Press
LO Temp
Refer to Programming
Instructions for instructions on
entering program locations.
(Wait 3-Seconds)
A 6
("Hold In" to Accelerate) ("Hold In" to Accelerate)
LO Temp
Perm Press
B 65
Proceed to next location
to be changed
To exit program mode,
open program switch
("Hold In" to Accelerate) ("Hold In" to Accelerate)
PL17
Refer to Programming
Instructions for instructions on
entering program locations.
Perm Press
A 6
(Wait 3-Seconds)
B 65
Perm Press
70F
LO Temp HI Temp
HI Temp
("Hold In" to Accelerate) ("Hold In" to Accelerate)
Program Location 16 (PL16) and Program Location 17 (PL17)
Maximum Active Anti-Wrinkle Time
Location to be viewed/changed.
Press “Perm Press” key. Display will
read “AGt,” maximum guard time for
3-seconds and then time programmed.
If no change, press “Perm Press” key,
otherwise press “HI” or “LO” key and
then “Perm Press” key.
Location to be viewed/changed.
Press “Perm Press” key. Display will
read “A,” and factor programmed for
3-seconds. If no change, press “Perm
Press” key, otherwise press “HI” or
“LO” key and then “Perm Press” key.
Display will read “B,” and factor
programmed for 3-seconds. If no
change, press “Perm Press” key,
otherwise press “HI” or “LO” key
and then “Perm Press” key.
Time Decrease Time Increase
Factor Increase
Factor IncreaseFactor Decrease
Programmable 1 to 9
Programmable 1 to 99
Factor Decrease