Owners Manual

112146-61 www.amdry.com 27
Program Location 08 (PL08)
Perm Press Cool Down Temperature/Time
Location to be viewed/changed.
Press “Perm Press” key.
Display will read “PPCd,” “Perm Press”
key cool down status for 3-seconds and
then cool down temperature and time
programmed. If no changes, press “Perm
Press” key twice. Otherwise, press “HI”
or “LO” key and then “Perm Press” key.
Summary: Cool down temperature is programmable from a minimum of 70° F to a maximum of 190° F in ten-degree increments
or from a minimum of 21° C to a maximum of 88° C in five-degree increments.
Cool down is programmable from 0 to 9 minutes.
PL08
PPCd
Perm Press
·100·3 HI Temp
Perm Press
LO Temp
Refer to Programming
Instructions for instructions on
entering program locations.
(Wait 3-Seconds)
Continued
from PL07.
100·3LO Temp HI Temp
Perm Press
PL09
Proceed to next location
to be changed
To exit program mode,
open program switch
Temperature Decrease
Temperature Increase
Time Decrease Time Increase