User manual

8 110803
Care and Use
Fire operation
 This appliance has both manual and remote operation.
 For safety and to save compromising the visual look of this appliance the controls
have been located behind the canopy, To access the controls press the top of the
canopy as shown in Fig 11. The canopy will open out from the top to reveal the
controls.
Power Switch (Fig. 11).
Press for Power On.
Press again for power off.
Always switch power off when not required to operate.
Flames (Fig. 12)
For Flame effect press button.
This will activate the light unit and produce flame flicker.
(Neon on left hand side will light up).
Pressing again switches the unit to “Standby”, left hand neon goes off.
Heat (Fig. 12)
1kW press the right hand button until the neon lamp lights Green.
2kW press the right hand button until the neon lamp lights Red.
No heat – press the right hand button until lamp goes off.
Press here to open Press here to close Open position
Fig.11
Fig.12
Neon
Buttons
Flame effect/ Standby
1 kW & 2 kW Heat settings
Power Switch