User manual

8 110803
I II
Care and Use
Fire operation
 For safety and to save compromising the visual look of this appliance the controls
have been located behind the canopy, To access the controls press the top of the
canopy as shown in Fig 11.The canopy will open out from the top to reveal the
controls.
Flames (Fig. 12)
For Flame effect, press button.
This will activate the light unit and produce flame flicker.
(Neon on)
Heat (Fig. 12)
Press switch I. This will activate the first element 1kW.
Press switch II. This will activate the second element 2kW.
Replacing the bulb
 Disconnect the appliance from the mains !
 Allow the appliance to cool.
 Do not use bulbs of a higher wattage.
 Ensure replacement bulb is 230-240 Volts~ 15 Watt,
with a Small Edison, Screw type fitting.
 Ensure that the bulb holder is held securely
When removing or replacing the bulb.
Remove the coals (D).
Remove the coal bed (C) by removing the two brackets.
(Fig. 8).
Unscrew the used bulb (Fig. 13).
Re-fit in reverse order.
Fig.13
Press here to open
Press here to close Open position
Fig.11
Fig.12
Neon
Anti clockwise
Clockwise