0102 095 50281 SLIMLINE TURBO (Flame System 5) USERS INSTRUCTIONS THIS CAT I2H APPLIANCE IS FOR USE ON NATURAL GAS G20 AT A SUPPLY PRESSURE OF 20 mbar IN GB & IE HAND THESE INSTRUCTIONS TO THE USER DESCRIPTION
The Slimline Turbo is a decorative gas fire which incorporates a horizontal flue that has been designed specifically to be used in applications that do not have a conventional chimney or flue but can be located so that the flue can terminate on an outside wall. The fire is switched `ON’ and `OFF’ from a push button situated on the right hand top corner of the surround and is controlled by a fully modulating thermoselector thermostat.
Clearances Side. Minimum clearance required to any combustible material to the side of the appliance must be 150mm. Shelves. Minimum clearance to the underside of a 150mm deep combustible shelf from the hearth must be 790mm, add 12.5mm to this dimension for every 25mm increase in the depth of the shelf. To light the appliance Press down the control button at the right top corner of the surround.
Spares and Service For spares and service contact your local supplier, installer or direct to the manufacturer stating that the appliance is a Slimline Turbo and quote the serial number from the data label located on the fascia panel. If the fire fails to light and no spark is heard - in the first instance a replacement battery should be obtained and fitted. To replace battery, remove the heat shield protecting the unit and slide battery forward.
