Technical data

18” Inset Taper 010710
2.5 LAYING THE BED 18 “ Inset
Fig. 19
Fig. 20
Page 11
Metal `stops’
The simulated front is positioned on the shelf directly
in front of the support shelf. Two metal `stops’ locate the
simulated front in position.
Fit the two front retaining brackets with the two No 8x3/8 screws
supplied in the fixing pack to secure the front into position (Fig. 4).
The support shelf is positioned on the fibre support
metalwork. There are two metal `stops’ that prevent
the support shelf from sitting on the main burner outlet
(Fig. 3).
Metal `stops’
Fig. 18
Note: Large coals/pebbles (grey) and small coals/pebbles
(black) are coloured for illustration purposes only!
Side View
Place 6 large coals/pebbles on top of the simulated front (one in
each groove). Allow the coals/pebbles to rest on the support
shelf. Place 5 large coals/pebbles on the on the first tier of the
support shelf (Fig. 5).
Place 6 small coals/pebbles
between the 6 large coals/pebbles
located on top of the simulated front.
Allow the coals/pebbles to rest on
the 5 large coals/pebbles on the first
tier.
Place 4 small coals/pebbles on top
of the 5 large coals/pebbles and
allow them to rest on the back tier of
the support shelf (Fig. 6).
Fi
g
. 17
To obtain the best visual appearance, it may be necessary to `slightly’ adjust the position of the coals.
If any of the coals or coal bed become damaged or lost, replacements MUST be obtained before further use.
ADDITIONAL COALS/PEBBLES MUST NOT BE USED
Front Retaining Bracket