User Guide

ManualsBrandsCrosskate ManualsOtherSTEERING SPRING

CROSCROS

CROS

SKSK

TETE

Crosskate Inc.

13R Bessom St.

Marblehead, M.A. 01945

1.877.CROSSK8

www.crosskate.com

Please refer to the Owner’s Manual that came with your skates

for other important mechanical, safety, and user information.

Changing Your Crosskate 616 Backcountry

Steering Springs

Tools needed:

5mm allen key

Flathead screwdriver

Step 1: Remove the PowerCarve Lockdown

Screw (2), and lift off the entire PowerCarve

Housing (4).

Step 2: Pry off the Steering Spring Cover (9)

with a flathead screwdriver, and remove the

existing Steering Springs and Steering Stop

Pin Cap (10).

Step 3: Load the new Steering Springs onto

the Stop Pin Cap (10).

Step 4: Reinstall the springs and cap into

the PowerCarve Housing (4). Refer to the

diagram to ensure that the stronger spring is

on the correct side for the left and right

skates.

Step 5: Replace the Steering Spring Cover

(9), and reinstall the PowerCarve Housing (4)

back onto the skate. Ensure that Steering

Stop Pin (3) goes into the Stop Pin Cap (10)

when you reinstall the assembly.

You may need to readjust your

PowerCarve Neutral Position.

The PowerCarve

system utilizes two springs of different

strengths. This design ensures the best steering response. We

advise that the springs be at least one strength grade apart.

Yellow= Light, Black= Medium, Red=Heavy, Green= Xtra Heavy

NOTE: If the steering is too responsive, install stiffer springs. If

the steering is too stiff, install lighter springs.

weaker

stronger

Please refer to the Owner’s Manual for

the full Crosskate Limited Warranty.

Left Side Housing Shown

Right Side is Opposite

Summary of content (1 pages)

PAGE 1
Changing Your Crosskate 616 BackcountryTM Steering Springs Please refer to the Owner’s Manual that came with your skates for other important mechanical, safety, and user information. L The PowerCarve TM system utilizes two springs of different strengths. This design ensures the best steering response. We advise that the springs be at least one strength grade apart. Yellow= Light, Black= Medium, Red=Heavy, Green= Xtra Heavy NOTE: If the steering is too responsive, install stiffer springs.