User Guide
MID POWER
4 x 37dBm Output
5G NR Compliant
© Sunwave CG_CF_M2 v2.1.0 | 24 of 47
Contact
us
today:
www.sunwave.com
cf_support@sunwave.com
4G TDD Configuration
To configure 4G TDD properties:
1. Open the A2 OMT and go to Settings -> TDD Configuration.
2. Turn on the TDD Switch in #1 and select the corresponding TDD modules in #2.
3. Select the UL-DL configuration in #3 and Select the Special Subframe Configuration in #4.
4. Select all TDD configurations and click Set in operation bar to validate them all.
Note: CrossFire supports the same TDD configuration for enabled modules in one system.
5. Click Query All to check if Sync Status is turning green to see if the module is configured to be paired to TDD signal.
Figure 25. TDD Configuration