User Guide
MID POWER
4 x 37dBm Output
5G NR Compliant
© Sunwave CG_CF_M2 v2.1.0 | 23 of 47
Contact
us
today:
www.sunwave.com
cf_support@sunwave.com
5G TDD Configuration
To configure 5G TDD properties:
1. Open the A2 OMT.
2. Go to Settings -> TDD Configuration.
3. Turn on the TDD Switch in #1.
4. Select the corresponding TDD modules in #2.
5. Input the 5G SSB Type in #3. CrossFire is supporting Case A and Case C.
6. Input whole 20 Slots Format for DL-UL configuration in #4.
7. Input Special Slot Format for DL-UL symbols configuration in #5.
8. Input SSB ARFCN in #6.
9. Select all TDD configurations and click Set in operation bar to validate them all.
Note: CrossFire supports the same TDD configuration for enabled modules in one system.
10. Click Query All to check if Sync Status is turning green to see if the module is configured to be paired to TDD signal.
Figure 24. TDD Configuration