User Guide
MID POWER
4 x 37dBm Output
5G NR Compliant
© Sunwave CG_CF_M2 v2.1.0 | 22 of 47
Contact
us
today:
www.sunwave.com
cf_support@sunwave.com
System Configuration
A2 Band Configuration
According to the different base station operating frequency bands for each operator, select the passive RF modules for
the A2 and active RF modules for the M2RU with the corresponding frequency band and set the Band properties in the
OMT of the Master A2. The limits of the uplink and downlink operating frequency bands correspond to the effective RF
range of the selected RF modules.
To set the Band properties:
1. Open the Master A2 OMT.
2. Go to Settings -> Band Configuration.
3. Check the Info Check to see if the module is valid in #1.
4. For modules 1~ 4, set the Uplink and Downlink Centre Frequencies and the Digital Signal Bandwidth in #2.
Note: The maximum bandwidth per operating band should not exceed 100MHz.
5. Click Set in operation bar.
6. In In-Service Bandwidth frame, click Update button of Band Configuration Update to update band configuration
(See #3). Then click Query all to ensure the value of Module 1~4 Info Check is valid in #1.
Figure 23. Band Properties