Installation Manual

HIGH POWER
43dBm Dual Band
Digital Radio
© Sunwave IM_CF_H2 v1.0.0 | 44 of 45
Contact us today:
www.sunwave.com
[e-mail]
RU Optical Port Description
Obtain the required lengths of optical fibers for all the optical connections and connect the fibers on the front panel of Remote Unit.
The interface type of SFP transceivers is an LC connector.
It is important to label all ports on the fiber distribution panel correctly.
It is recommended to include additional length/slack in the optical fiber to allow future re-configurations without requiring
additional splices.
RU Front Panel Interfaces
SN
Interface Name
Description
1
CH2
PA 2 Module Interface, 4.3-10 female Connector
2
CH1
PA 1 Module Interface, 4.3-10 female Connector
3
Air Pressure hole
Make the pressure balance
4
Slave OP
Connection for EU or RU at the next higher level
5
Slave
Indicates Slave OP port operating status
6
MASTER OP
Connection for RU at the next lower level
7
Master
Indicates Master OP port operating status
8
RUN
Indicates device operating status
9
DEBUG
Connection for local PC through CAT-5 for local monitoring
10
GE
Reserved
11
PWR
Electrical Power Line Interface