User manual

In order to ensure the best performance and durability from the clutch, always be sure you have proper

clutch freeplay. Freeplay is needed to ensure that the clutch has room for wear. A clutch with no freeplay

will begin to slip as the discs wear down. Failure to fix a slipping clutch can cause clutch damage. To check

the freeplay, simply pull on the clutch lever. The lever should move very easily within the freeplay range

before you feel the clutch begin to engage. If too much or too little freeplay exists, adjustments are needed.

The distance between the clutch lever and the grip may be

adjusted.

1. Loosen the clutch adjuster lock nut

2. Turn the adjuster clockwise to add freeplay and

counterclockwise to remove free-play.

A second adjustment may be needed if the clutch is slipping or if the clutch will not engage. Follow the

steps below carefully to perform the adjustment. If the clutch is slipping, you will need to decrease the

amount of clutch engagement. If you squeeze the clutch lever all the way and the clutch still will not

engage, you need to increase the engagement. (Clutch Freeplay 10 – 15 mm)

1. Loosen the lock nut

2. Move the integral cable adjuster and lock in to place

with the adjuster nut to obtain the specified free-

play.

3. Tighten the lock nut and check the adjustment.

4. Start the engine and pull the clutch lever in and shift

into gear. Make sure the engine does not stall and the

motorcycle does not creep forward.

5. Gradually release the clutch lever and open the throttle.

The motorcycle should move smoothly and accelerate

gradually.

6. If you cannot get the proper adjustment, see you

Xmotos dealer or service center.

BASIC MAINTENANCE PROCEDURES

CLUTCH SYSTEM (if equipped)

CLUTCH LEVER ADJUSTMENT

INTEGRAL CABLE ADJUSTMENT