Operation Manual

WAKE User Manual
11
To remove the battery, follow the steps below:
1. Unscrew the two screws back cover at the downside of the device;
2. Snap the space between the middle of the back cover and your handset,
push the cover backward;
3. Raise the bottom of the battery;
4. Take it out from the battery compartment.
To install the battery, follow the steps below:
1. Insert the top of the battery into the flat with bottom metal contact of the
battery aligned with that of the flat;
2. Slide the back cover to the phone until it closes in place;
3. Tighten the two screws on the battery cover.
Warning: Power off the device first and remove the battery before taking the
SIM card out; otherwise, your SIM card may be damaged.
Charging the battery
The battery owns half electric quantity initially, can be immediately used after
unpacking. It performs best after full charge/discharge for the first three times.
 In charging mode, the battery indicator flashes. If the device is switched
off during charging, a charging indicator appears on the screen, indicating
that the battery is being charged. If the battery is totally discharged, it
may take a few minutes before the charging indicator shows.
 When the battery is fully charged, the indicator displays full battery and
stops scrolling. If your device is turned off, an image indicating that the
battery is fully charged appears on the screen. Generally, the charge
process takes two and half an hour. During the charge process, your
battery, device, and the charger may become warm. This is normal.
 When charging is finished, disconnect the AC socket from the charger
and your phone.
Note: Please place your phone at the ventilated place with the temperature
ranging from -10°C to +55°C. Use the provided charger only. Using
unauthorized chargers may cause danger and violate the warranty rules of the
phone. If charging causes too high or low temperature, the device warns
automatically and charging is stopped, avoiding damages or dangers.