Installation Manual
Table Of Contents
- About This Document
- 1 Introduction
- 2 Quick Start for the OEM Kit Users
- 3 Product Overview
- 4 IRIS OEM Reference Board
- 5 Power
- 6 Radios
- 7 Antennas
- 8 Flash Data Logger and Serial ID Chip
- 9 Atmega1281 Fuses
- 10 Sensor Boards & Expansion Connectors
- 11 USB Programming Pod
- 12 Appendix A. Warranty and Support Information
IRIS OEM Edition Hardware Reference Manual
Table 11-1. Pin outs for USB Connection
Pin No. Name Description
1 VBUS Powered Supply Pin
2 USBDM USB Data Signal Minus
3 USBDP USB Data Signal Plus
4 GND Ground Supply Pin
11.6 Programming Interface
The programming interface provided by MIB520 debug pod is via 10-pin connector. The pin-out
details for this connector are provided in Table 11-2.
1
9
210
1
9
210
Table 11-2. Pin outs for programming connector
Pin No. Name
1 ADC4
2 ADC6
3 GND
4 RSTN
5 UART_RXD0
6 SPI_SCK
7 VCC
8 UART_TXD0
9 ADC5
10 ADC7
When OEM customers layout their boards, it is a good idea to provide this 10-pin mating
interface to facilitate the programming of OEM edition modules. The part numbers for the
mating header/receptacle are shown in Table 11-3. These can be purchased from Digi-Key.
Table 11-3. 10-pin mating header/receptacle
Type Digi-Key PN AMP PN
Male A26267-ND 103308-1
The MIB520 debug pod is also provided with 10-pin to 51-pin adapter to facilitate the
connectivity to Crossbow’s MICA family processor/radio and sensor boards.
Page 32 Doc. # 7430-0549-01 Rev. B