Installation Manual
Table Of Contents
- About This Document
- 1 Introduction
- 2 Quick Start for the OEM Kit Users
- 3 Product Overview
- 4 IRIS OEM Reference Board
- 5 Power
- 6 Radios
- 7 Antennas
- 8 Flash Data Logger and Serial ID Chip
- 9 Atmega1281 Fuses
- 10 Sensor Boards & Expansion Connectors
- 11 USB Programming Pod
- 12 Appendix A. Warranty and Support Information
IRIS OEM Edition Hardware Reference Manual
Chip AT86RF230
Radio Frequency (MHz)
2400
RF Transceiver (Radio)
TMax. Data Rate (kbits/sec)T
250
Chip AT45DB041D
Connection Type SPI
Flash Data Logger Memory
Size (kB) 512
3.1 Block Diagram and Schematics for the OEM Edition Module
Figure 3-2. Block Diagram for the OEM Edition Module
3.2 Electrical Specifications
The electrical specifications for the OEM Edition module are provided in Table 3-2.
Table 3-2. M2110 Electrical Specifications
Parameter Operating Value
Power supply 2.7 to 3.6 Volts
I/O See Table 3-4
GPIO levels 0 - VCC
GPIO current (source/sink) 10 mA max
UART levels 0 - VCC
UART data rate Up to 115kB
I2C rate 100 kbps max
I2C levels 0 - VCC
Interrupt levels 0 - VCC
RF port 50 ohm
3.3 Environmental Specifications
The environmental specifications for the OEM Edition module are provided in Table 3-3.
Doc. # 7430-0549-01 Rev. B Page 9