Owner`s manual

(2) primary wire connector (4) nut
(3) bolts (5) ignition coil
9. Remove the cylinder head cover (page 55).
Servicing Your Honda 65
Piston/Piston Rings/Piston Pin
Cylinder Head Removal
1. Clean the area above the engine before
disassembly to prevent dirt falling into the
engine.
2. Drain the radiator coolant after cooling the
motorcycle (page 42).
3. Remove the seat and fuel tank (page 29, 30).
4. Remove the muffler (page 87) and subframe
(page 32).
5. Remove the carburetor (page 119).
6. Remove the exhaust pipe (page 89).
7. Disconnect the spark plug cap (1) and remove
any dirt from around the spark plug base.
8. Disconnect the primary wire connector (2).
Remove the bolts (3), nut (4) and ignition coil
(5).
11. Position the piston at top dead center on the
compression stroke (page 55).
Remove the camshaft holder assembly (page
57).
12. Loosen the radiator hose clamp screw (7) and
disconnect the radiator hose (8).
(7) radiator hose clamp screw
(8) radiator hose
10. Remove the spark plug (6).
(5)
(4)
(2)
(3)
(1) spark plug cap
(1)
(6) spark plug
(6)
(8)
(7)
(cont’d)
054-075.qxd 06.5.11 13:03 ページ65