Owner`s manual

32 Servicing Your Honda
(14)
(12)
(13)
Subframe Removal
Refer to Safety Precautions on page 19.
Removal
1. Remove the seat (page 29).
2. Remove the side covers (1) by removing the
bolts (2).
(1) side covers
(2) bolts
3. Loosen the muffler clamp bolt (3).
4. Remove the muffler A bolt (4), muffler B
bolt/washers (5) and muffler (6).
(3) muffler clamp bolt
(4) muffler A bolt
(5) muffler B bolt/washers
(6) muffler
5. Disconnect the crankcase breather tube (7).
6. Unhook the air cleaner case cover (8).
7. Unhook the fuel tank band (9), and remove it.
8. Loosen the screw (10) on the air cleaner
connecting tube clamp (11).
(7) crankcase breather tube
(8) air cleaner case cover
(9) fuel tank band
(10) screw
(11) air cleaner connecting tube clamp
9. Remove the subframe mounting lower bolts
(12) and subframe mounting upper bolts (13).
Then remove the subframe (14) by pulling it
straight backward.
(12) subframe mounting lower bolts
(13) subframe mounting upper bolts
(14) subframe
Installation
1. Loosely attach the upper and lower ends of
the subframe (1) to the mainframe while
connecting the air cleaner connecting tube to
the carburetor. Then align the subframe with
the rear wheel and tighten the subframe
mounting upper bolts (2) and subframe
mounting lower bolts (3) to the specified
torque:
upper bolts:
22 lbf·ft (30 N·m, 3.1 kgf·m)
lower bolts: 36 lbf·ft (49 N·m, 5.0 kgf·m)
(1) subframe
(2) subframe mounting upper bolts
(3) subframe mounting lower bolts
(1)
(2)
(6)
(5)
(4)
(3)
(9)
(8)
(10)
(11)
(7)
(1)
(3)
(2)
024-053.qxd 06.5.11 11:58 ページ32