Owner`s manual

Carburetor Adjustments & Tuning Tips
Adjustments for Competition 123
(1) throttle cables
(2) hot start cable
(3) throttle position sensor connector
(4) air vent hoses
(5) overflow hose
(2)
(3)
(1)
(5)
(4)
(4)
(5)
(4)
(4)
Carburetor Assembly
To assemble, reverse the disassembly procedures.
To install the carburetor, reverse the removal
procedures.
Tighten the following parts to the specified
torque.
float bowl screws:
1.5 lbf·ft (2.1 N·m, 0.2 kgf·m)
accelerator pump cover screws:
1.5 lbf·ft (2.1 N·m, 0.2 kgf·m)
carburetor top cover bolts:
1.5 lbf·ft (2.1 N·m, 0.2 kgf·m)
jet needle/holder assembly:
1.5 lbf·ft (2.1 N·m, 0.2 kgf·m)
rink arm set torx screw:
1.5 lbf·ft (2.1 N·m, 0.2 kgf·m)
throttle drum cover bolt:
2.5 lbf·ft (3.4 N·m, 0.3 kgf·m)
hot start cable nut:
1.5 lbf·ft (2.1 N·m, 0.2 kgf·m)
throttle cable lock nut:
3.0 lbf·ft (4 N·m, 0.4 kgf·m)
throttle cable bolt:
3.0 lbf·ft (4 N·m, 0.4 kgf·m)
• After installing the carburetor, adjust the
throttle cable (1) freeplay and hot start cable
(2) freeplay.
• After installing the carburetor, check the
throttle position sensor connector (3) for
correct routing.
• After installing the carburetor, check the air
vent hoses (4) and overflow hose (5) for
kinking or pinching and correct routing.
118-133.qxd 06.5.11 13:13 ページ123