Owner`s manual

Rear Suspension Adjustments
Adjustments for Competition 109
Pin spanners should be used for turning the lock
nut and adjusting nut. See page 148 for optional
pin spanners.
Spring pre-load length (Standard spring)
Standard:
10.11 in (256.7 mm)
Min. : 9.80 in (249.0 mm)
Spring pre-load length (Optional spring)
Min. (Softer, 5.3 kgf/mm): 9.9 in (251 mm)
Min. (Stiffer, 5.7 kgf/mm): 9.9 in (251 mm)
Min. (Stiffer, 5.9 kgf/mm): 9.8 in (250 mm)
The rear suspension can be adjusted for the
rider’s weight and riding conditions by changing
the spring pre-load and the rebound and
compression damping.
The rear shock absorber assembly includes a
damper unit that contains high pressure nitrogen
gas. Do not attempt to disassemble, service, or
dispose of the damper; see your Honda dealer.
The instructions found in this owner’s manual are
limited to adjustments of the shock assembly
only.
Puncture or exposure to flame may also result in
an explosion, causing serious injury.
Service or disposal should only be done by your
Honda dealer or a qualified mechanic, equipped
with the proper tools, safety equipment and the
official Honda Service Manual.
If your CRF is new, put enough part-throttle
break-in time (about one hour) on it to ensure
that the suspension has worked in.
Rear Suspension Spring Pre-Load
Pre-load should be adjusted when the engine is
cold because it is necessary to remove the
muffler (page 87).
An optional pin spanner is available for turning
the lock nut and adjusting nut to adjust spring
pre-load.
1. Place your CRF on an optional workstand or
equivalent support with the rear wheel off the
ground.
2. Loosen the connecting tube clamp screw and
remove the rear subframe’s three mounting
bolts, then remove the subframe. See page
32.
3. Check that the spring pre-load is adjusted to
the standard length. Adjust as necessary by
loosening the lock nut (1) and turning the
adjusting nut (2).
Each complete turn of the adjuster nut
changes the spring length by 1/16 in (1.5
mm).
4. After adjustment, hold the adjusting nut and
tighten the lock nut to the specified torque:
32 lbf·ft (44 N·m, 4.5 kgf·m)
(1) lock nut (3) pin spanners
(2) adjusting nut (4) spring length
To increase spring pre-load:
Loosen the lock nut with the optional pin
spanners (3) and turn the adjusting nut to shorten
the spring length (4). Do not shorten to less
than:
9.80 in (249.0 mm)
To decrease spring pre-load:
Loosen the lock nut with the optional pin
spanners (3) and turn the adjusting nut to
increase the spring length (4). Do not increase to
more than:
10.15 in (257.7 mm)
Each turn of the adjuster changes spring length
and spring pre-load. One turn equals: spring
length:
1/16 in (1.5 mm)
(1)
(4)
(2)
(3)
094-117.qxd 06.5.11 13:09 ページ109