Instruction manual

The micro controller in the 2082-141-xx determines the switch position by detecting the presence of switch
common voltage on either Pos1 or Pos2. If no presence of switch common voltage is detected then the
position is reported as “ERROR!”. The 2082-141-xx will not send waveguide switch control signals if it
cannot determine a valid switch position.
There are three possible methods for a user to override auto switching while in Manual mode to perform
waveguide switch testing. These methods are referred to as LOCAL (which provides two (2) possible ways)
and REMOTE (one (1) way). These are described below.
2082-14x-47 Manual, Rev. B Page 7 12/19/13