Instruction manual

3.0 ETHERNET Interface Installation and Operation
The 2082-14x-47 Block Downconverter is equipped with a 10/100 Base-T compatible Ethernet interface for
control and monitoring of its operating parameters. An HTML script interface allows the user to monitor and
control the converter using a standard web browser. SNMP (Simple Network Management Protocol) is also
supported. Contact Cross Technologies for the SNMP MIB file.
3.1 Methods of Connection
Directly Connected to a PC:
For control from a local PC, attach the 2082-14x-47’s Ethernet port to the Ethernet network connector on the
PC using a crossover RJ-45 cable.
LAN Connection
For LAN connections, attach the 2082-14x-47 Ethernet port to the LAN using a normal RJ-45 cable.
Use any PC on the LAN to connect to the 2082-14x-47.
3.2 Ethernet Configuration
Each 2082-14x-47 must be configured with an appropriate IP address, Netmask, and Gateway assigned by your
network manager. The 2082-14x-47 is set at the factory with the following network settings:
Factory Network Settings
IP Address: 192.168.123.2
Subnet Mask 255.255.255.000
Gateway 000.000.000.000
The network settings may be changed via the front panel or from the web browser interface.
2082-14x-47 Manual, Rev. B Page 26 12/19/13