Instruction manual

2.5 Menu Settings
2.5.1 Functions
This section describes operation of the front panel controls. There are three operator switches, the
LCD display and alarm indicator LEDs. All functions for the equipment are controlled by these components.
The functions are (see Figure 2.4):
Power Up
Normal Display
Menu 1 Select AUTO/MANUAL mode
NOTE: If MANUAL mode, then --> Menu 1a Manually set switch positions.
Menu 2 Select LOCAL/REMOTE mode
Menu 3 Set AMP1 Window? Y/N
If Y then --> Menu 3a Indication of Nominal value and Actual Measured value of AMP1 current
Menu 3b Set Nominal current to Actual Measured value of AMP1 current? Y/N
IF N then --> Menu 3b.1 Manually Set AMP1 Nominal Current
Menu 3c Set AMP1 Window
Menu 4 Set AMP2 Window? Y/N
If Y then --> Menu 4a Indication of Nominal value and Actual Measured value of AMP2 current
Menu 4b Set Nominal current to Actual Measured value of AMP2 current? Y/N
IF N then --> Menu 4b.1 Manually Set AMP2 Nominal Current
Menu 4c Set AMP2 Window
Menu 5 Set Remote Interface
Menu 6 Set RS485 Remote Address
Save Menu When “R” is selected or when get to the end
Alarm indications appear on the LEDs (see Figure 2.2).
All program changes must start with the operation of the Menu/Execute switch and must also end with the
operation of the Menu/Execute switch verified by the “Save Settings?” Menu. If this sequence is not followed,
none of the changes will take effect. If programming is initiated and no operator action takes place for
approximately 12 seconds (before the final press of the Menu/Execute switch) the display will revert to its
previous status and you will need to start over.
2082-14x-47 Manual, Rev. B Page 20 12/19/13