Instruction manual

2.3 Front Panel Controls and Indicators
Figure 2.2 shows the front panel controls and indicators.
MENU
EXECUTE
UNIT 1
UNIT 2
450
380
1
POWER
STATUS
STATUS
MODE
212
ALARM
STDBY
ONLINE
MANUAL
LOCAL
REMOTE
AUTO
PATH
1>1
DS8, DS9 - POWER LEDs
Light Green when DC
power is present from PS1
and/or PS2.
DS4 - AMP1 STATUS LEDs
Indicate whether AMP1 is in
Standby mode, Online, or in
an Alarm state.
DS5 - AMP2 STATUS LEDs
Indicate whether AMP2 is in
Standby mode, Online, or in
an Alarm state.
DS7 - MODE LEDs
Indicate if 2082 is in
AUTO or MANUAL mode,
and LOCAL or REMOTE
mode.
LCD DISPLAY
Displays measured current in
each unit/amp, and the current
paths.
S1 - MENU/EXECUTE BUTTON
Press this to get into Program mode
and to execute any changes.
S2 - VERT. TOGGLE
Vertical toggle switch that
controls values in the Menu
items when in program mode.
Does not function in the normal
display mode
S3 - HORIZ. TOGGLE
Horizontal toggle switch
that controls which values
are being adjusted. Does
not function in the normal
display mode
FIGURE 2.2 2082-14x-47 Front Panel Controls and Indicators
TABLE 2.4 LED Indic
a
ators
TABLE 2.4 LED Indicators
LED Function
POWER1 Illuminates GREEN when power supply 1 is on
POWER2 Illuminates GREEN when power supply 2 is on
STATUS1, ALARM Illuminates RED when a fault is detected from AMP1 monitor
STATUS1, ONLINE Illuminates GREEN when AMP1 is online
STATUS2, ALARM Illuminates RED when a fault is detected from AMP2 monitor
STATUS2, STDBY Illuminates YELLOW when AMP2 is not backing up AMP1
STATUS2, ONLINE Illuminates GREEN when AMP2 is online
AUTO Illuminates GREEN when controller is in auto mode
MANUAL Illuminates YELLOW when controller is in manual mode
LOCAL Illuminates GREEN when unit is in local mode
REMOTE Illuminates YELLOW when unit is in remote mode
2082-14x-47 Manual, Rev. B Page 18 12/19/13