Instruction manual

1.4.1 LOCAL. As mentioned above, local provides two possibilities to override auto switching. The first is
via the
Front Panel Menu and the second is via the Manual Override Knob located on the waveguide switch
(if so equipped.) Both of these require that the 2082-14x-47 be placed in the MANUAL MODE.
1.4.2 Front Panel Menu.
To override auto switching via the Front Panel Menu …
1) Place the unit in MANUAL MODE.
2) The LCD display will display the following message showing the current location of the switch:
Manually Set
POS=1>1
R
3) You may now select switch positions using the UP/DOWN switch. For a 2082-14x-47, 1 for 1
controller, the switch position choices are: 1>1 (Primary active), or 2>1 (Backup active).
4) Once the Switch position is selected, push the PROGRAM/EXECUTE switch to go to the next menu.
5) Use the LEFT/RIGHT switch to move the cursor to R (return), then push the PROGRAM/EXECUTE
switch to jump to the SAVE SETTINGS menu.
1.4.3 Manual Override Knob.
To override auto switching via Manual Override Knob …
1) Place the unit in MANUAL MODE.
2) The LCD display will display the following message showing the current location of the switch:
Manually Set
POS=1>1
R
3) Once testing has been completed, the 2082-14x-47 Redundant Unit Controller should be restored to
AUTO mode.
2082-14x-47 Manual, Rev. B Page 10 12/19/13