Instruction manual

2.2 Controls and Indicators -The following are the controls and indicators.
SWITCH
MOD
E
SWITC
H
CH 1
ON-
POWER
1 2
1
AUTO 2
MANUAL
SELECT
ALARM
HISTOR
MANUAL CH 2
ON-LINE
STATUS
REMOTE HISTORY
RESET
SWITCH
RESET
1 2
ALARM
1 2
FIGURE 2.2 1582-70L CONTROLS AND INDICATORS
TABLE 2.1 FRONT PANEL CONTROLS AND INDICATORS
Item Description
CH1 ON-LINE LED Turns green when Channel 1 is selected
CH2 ON-LINE LED Turns green when the Channel 2 is selected
MANUAL LED Turns red when the Manual Select switch manually selects channel 1 or 2.
ALARM CH1 LED Turns red when Channel 1 alarm input is a closure or open (selectable)
ALARM CH2 LED Turns red when Channel 2 alarm input is a closure or open (selectable)
ALARM HISTORY 1 Turns red on Channel 1 alarm and stays red until HISTORY RESET
is pushed
ALARM HISTORY 2 Turns red on Channel 2 alarm and stays red until HISTORY RESET
is pushed
POWER CH1 LED Turns green when power is applied to AC1 input on the rear panel
POWER CH2 LED Turns green when power is applied to AC2 input on the rear panel
REMOTE LED Turns amber when REMOTE control is active
MANUAL SELECT 3-position switch as follows:
1 - manually select Channel 1
center - auto - switch position determined by alarm and Remote closures
2 - manually select Channel 2
If operating in the ICS mode, the last channel manually selected
(CH1 or CH2) will be the initial channel.
SWITCH RESET Resets switch to CH1 if it is good and switch is in the latch mode,
Also Resets REMOTE selection to normal AUTO operation
HISTORY RESET Resets history alarm LEDs only
TABLE 2.2 PC BOARD SETTINGS
NOTE: Dot position means jumper goes from pins 1-2; non-dot means jumper goes from pins 2-3
1582-70L Manual, Rev. B Page 6 11/05/09