Technical data

18 Agilent N5508A Hardware Reference
1 General Information
IF LEVEL
This output connector is not used for phase noise measurements.
Power Connector (~ LINE)
This is the connection for the AC power cord. The detachable power cord is the
test set’s disconnecting device. It disconnects the mains circuits from the
mains supply before other parts of the instrument or system. For information
on power requirements, see “General Specifications" on page 20.
MULTIPLEXER: OUT
The signal at this connector is the voltage that is measured by the internal
vol tmeter.
Characteristics
• Output level range: ±10 V
• Output impedance: 1 k
Ω
• Bandwidth: 100 kHz
TUNE SPAN OUT
This connector is not used for phase noise measurement.