Technical data

General Information 1
Agilent N5508A Hardware Reference 17
600 MHz OUT: 0 dBm
The signal at this connector is an output of the 600 MHz Output oscillator.
Characteristics
• Output impedance: 50 Ω
• Typical output power: 0 dBm
Operating considerations
External tuning: Tune this frequency by applying a voltage to the VOLTAGE
CONTROL connector.
600 MHz OUT: +20 dBm
The signal at this connector is an output of the 600 MHz oscillator.
Characteristics
• Output impedance: 50 Ω
• Typical output power: +20 dBm
Operating considerations
External tuning: Tune this signal by applying a voltage to the VOLTAGE
CONTROL connector.
Buffered 10 MHz Out
The signal at this connector is the signal at the rear-panel 10 MHz IN connector
after it has been buffered by an amplifier.
Characteristics
• Output impedance: 50 Ω
• Typical output power: +7 dBm
Operating considerations
When the reference chain tuning sensitivity is set to 1.0 ppm/V, this output is
switched off.
GPIB
GPIB communication between the source and the system occurs through this
connection.