Instruction manual

2.2 Rear Panel Input/Output Signals - Figure 2.2 shows the input and output connectors on the rear panel.
AC
GND
J18
AC - POWER IN
AC input for switching
power supply.
100-240 ±10% VAC, 47-60 Hz.
J2 - CH1 INPUT
0.1-100 MHz input,
-50 to 0 dBm
BNC female 50Ω
J1 - CH1 OUTPUT
0.1-100 MHz output,
+10 dBm max
BNC female 50Ω
J10
AND
MONITOR
CONTROL
J10 - MONITOR AND CONTROL
DB9 female connector.
see Table 2.1.
J4
INPUT
J5 - CH2 OUTPUT
0.1-100 MHz output,
+10 dBm max
BNC female 50Ω
J4 - CH2 INPUT
0.1-100 MHz input,
-50 to 0 dBm
BNC female 50Ω
CHANNEL 1
CHANNEL 2
J1
OUTPUT
15 234
678
9
J5
OUTPUT
J2
INPUT
FIGURE 2.2 Rear Panel I/Os
TABLE 2.1
J10
2.1 J10 Pinouts (RS-232C/485*)
Pin Function
1 Rx-
2 Rx+ (RS-232C)
3 Tx+ (RS-232C)
4Tx-
5GND
6 Alarm Relay: Common
7 Alarm Relay: Normally Open
8 Not Used
9 Alarm Relay: Normally Closed
*Remote Serial Interface
Interface: DB-9 Male
Protocol: RS-232C (RS-232C/422/485 -option Q),
9600 baud rate, no parity, 8 data bits, 1 start bit, 1 stop bit.
1200-88 Manual, Rev. A Page 8 8/18/10
TABLE 2.2 Connector
2.2 Connector Options
Option IF
STD BNC, 50Ω
-B BNC, 75Ω
-F Type-F, 75Ω