Technical Manual
Technical Manual  
ARGUS AM Floor System     
Regulatory information  v1.2  Page 65 of 65 
15  Regulatory information 
FCC WARNING 
This device complies with Part 15 of the FCC Rules. Operation is subject to the following 
two conditions: (1) This device may not cause harmful interference, and (2) this device 
must accept any interference received, including interference that may cause undesired 
operation. 
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B 
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide 
reasonable  protection  against  harmful  interference  in  a  residential  installation.  This 
equipment generates uses and can radiate radio frequency energy and, if not installed in 
accordance with the instructions, may cause harmful interference to radio communications. 
However, there is no guarantee that interference will not occur in a particular installation. If 
this equipment does cause harmful interference to radio or television reception, which can 
be determined by turning the equipment off and on, the user is encouraged to try to correct 
the interference by one or more of the following measures: 
-  Reorient or relocate the receiving antenna. 
-  Increase the separation between the equipment and receiver. 
-  Connect  the  equipment  into  an  outlet  on  a  circuit  different  from  that  to  which  the 
receiver is connected. 
-  Consult the dealer or an experienced radio/TV technician for help. 
NOTE 2: Any changes or modifications to this unit not expressly approved by the party 
responsible for compliance could void the user’s authority to operate the equipment. 
IC WARNING 
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to 
the following two conditions: 
(1) This device may not cause interference; and  
(2)  This  device  must  accept  any  interference,  including  interference  that  may  cause 
undesired operation of the device. 
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils 
radio exempts de license. L’exploitation est autorisée aux deux conditions suivantes: (1) 
l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter 
tout brouillage readioélectrique subi, même si brouillage est susceptible d’en compromettre 
le fonctionnement. 
CAN ICES-3 (B)/NMB-3(B) 










