Technical Manual

Technical Manual
ARGUS AM Floor System
Cross Point Device Explorer v1.2 Page 58 of 65
13.6 System
Clicking the System hyperlink in the Main menu or clicking the System information section
in the dashboard will open the System information screen.
Figure 57: System information & notifications
The top-part of this screen shows information about the connected transceiver(s) and
whether the firmware of all connected devices is up-to-date. The bottom part shows 3 tabs:
13.6.1 Notifications
In case of an alarm situation, notifications will be used to draw attention and to present
information about the type of alarm.
Notifications can be set for all entrances at once by configuring the notifications in this
System screen. In case different notifications per entrance are required, select the entrance
and specify the required notification settings at entrance level. See section 13.5.6.2 for
more details.
Notification settings, which are configured in this System screen, will be
applied system-wide, which means to all devices connected to this
Access Point. Any notification settings that have been configured for a
specific entrance will be overwritten with the values that are specified in
this System screen!
Refer to section 13.5.4 for more details on the available notification settings.