Technical Manual

Technical Manual
ARGUS AM Floor System
Cross Point Device Explorer v1.2 Page 51 of 65
Settings
The Settings view screen shows various available settings for the ARGUS AM Floor
System.
Figure 48: Settings
This page lets you select whether extra receiver antennas are used or not. In case you are
installing an extended configuration, like transceiver antenna + 2 receiver antennas, then
both checkboxes must be ticked to activate the receiver channels. If only one receiver
antenna is used, make sure to tick the checkbox that corresponds with the receiver channel
to which the actual receiver antenna is connected to the control unit. Activate these settings
by clicking the Apply button.