Technical Manual

Technical Manual
ARGUS AM Floor System
Cross Point Device Explorer v1.2 Page 50 of 65
also receiver antennas are connected, the signals received by these receivers can be
viewed by selecting the receiver from this list.
Scan scale factor
The Scan scale factor lets you zoom-in on the received signals. When this value is
increased, the signals that are shown in the view will increase in size. A higher scale factor
is very helpful to find the position of the transmission bursts of other AM systems in the
area, especially when their signals are too weak to see in the low scale factor view. When
other weak AM transmission bursts are made visible with a higher scan scale factor, then
this will enable you to properly synchronize our TRx transmission burst with these
neighboring systems.
The Scan scale factor is only related to the zoom level of the signal views
and has no relation to the detection sensitivity of the system.
Temporarily disabling other device bursts
When you start synchronizing entrance(s), start by selecting the Synchronization page of
the first device. It is very useful to switch the transmission bursts of all other entrances off,
so you can determine if there are any other AM systems in the area, to which you must
synchronize your system.
To switch the transmission bursts of the other devices off, select the Automatic
synchronization button to unfold a list of all other available devices.
Click on the green checkmark in front of the device name to disable the transmission
burst of that device. The disabled icon will appear, indicating the transmission burst for
that device is switched off. Click this icon again to switch the burst on again.
When you leave the Synchronization page, all disabled devices will automatically start
bursting again.