Technical Manual

Technical Manual
ARGUS AM Floor System
Cross Point Device Explorer v1.2 Page 49 of 65
Just hover the mouse cursor over our transmission burst (the cursor will change to a
horizontal double arrow) and press down your left mouse button. While keeping the mouse
button pressed, move the transmission burst and position it on top of the other system’s
transmission burst. Together with moving the transmission burst, also the receiver window
will move automatically since it has a fixed distance to the transmission burst.
Figure 47 shows the correct way to synchronize our system with another AM system in its
vicinity.
Figure 47: AM synchronization – correct adjustment
View settings
Here you can select on which channel(s) you want to view the synchronization signals.
Rx1
The Rx1 channel shows the filtered signals received by the optional receiver antenna,
which is connected to the input RX1 of the Control Unit board.
Rx2
The Rx2 channel shows the filtered signals received by the optional receiver antenna,
which is connected to the input RX2 of the Control Unit board.
TRx
The TRx channel shows the filtered signals received by the transceiver antenna.
Wideband receiver & wideband channel
When selected, the Wideband receiver channel shows the raw and unfiltered signals and
gives a clear view on the received signals on the antenna that is selected from the
Wideband channel list. By default it shows the signals received by the TRx antenna. When
Our system’s
detection window
(red bar)
Other system’s
transmission bursts
(blue curve)
Our system’s
transmission burst
window (orange bar)