Technical Manual

Technical Manual
ARGUS AM Floor System
AM operating principle v1.2 Page 13 of 65
Figure 3: Correcting the delay time of system B
Figure 4 shows two AM systems that are properly synchronized.
Figure 4: Two AM systems properly synchronized
The synchronization can be performed by making use of Cross Point’s software. The exact
synchronization procedures are described in chapter 13.5.7.2.
Transmission burst
Receiver window
20ms
0ms
Transmission burst
Receiver window
System A
System B
50Hz mode
Transmissio
n burst
Receiver window
20ms
0ms
Transmission burst
Receiver window
System A
System B
50Hz mode