Technical Manual

Technical Manual RF Mono
Equipment and tools v1.4 Page 9 of 47
4 Equipment and tools
The following equipment and tools are advised to use when installing and tuning the RF
Mono system.
4.1 General installation tools
The general tools required for installation of an EAS system (drills, screwdrivers, cutters,
etc.) are not described in detail.
4.2 Laptop computer
To properly adjust the RF Mono system through Cross Point’s Device
Explorer software, it is required to use a Windows based (laptop)
computer.
The following minimal requirements are set for the laptop:
 Intel 1.3GHz or faster processor
 Microsoft Windows 7 with Service Pack 1 (32 bit and 64 bit)
 Microsoft .NET Framework 3.5 Service Pack 1
 512MB of RAM (1024MB recommended)
 50MB of available hard-disk space for Device Explorer
 Minimal screen resolution 1024x768 (recommended 1600x1200)
 Video hardware acceleration
4.3 Software
The various antennas are interconnected through the Cross Point Field Bus (see
chapter 5.2 for further details on the Field bus structure).
To be able to adjust and configure the various devices, Cross Point Device Explorer is
required.
Please refer to the Cross Point Device Explorer User Manual for further details on all
features and general usage of this software.