Technical Manual

Technical Manual RF Mono
Introduction v1.4 Page 6 of 47
On RF Mono systems, pins 3 and 6 are used for synchronization purposes between the
antennas, which are based on a completely different signal compared to AM systems.
Connecting AM systems and RF Mono systems to the same Field Bus will result in bad
performance and synchronization!
2.5.2 Detection distances
Any specified detection distances are maximum values. Dependent of environmental
noise these maximum values might not be achieved and aisle widths need to be reduced
to obtain good system performance. See chapter 3 for more details on potential noise
sources and installation guidelines.
2.5.3 RF Deactivators
In case RF Deactivators need to be installed in combination with the RF Mono system, it
is mandatory to use Cross Point’s Checkout RF Deactivators or Connected RF
Deactivators. These devices will function properly and without interference in combination
with the RF Mono system.
Do not use other brands RF Deactivators, as they will introduce noise
and degrade the performance of the RF Mono system.